Page:measure:pgusetup:pulse:pgu<N>:Base - Agilent Technologies 4155C Command Reference Manual

Syntax
Parameter
Query response
Example
:PAGE:MEASure:PGUSetup:PULSe:PGU<n>:BASE
This command sets the BASE VALUE of PGU<n>.
<n> is required to specify PGU number. Valid PGU numbers are PGU1 through
PGU2.
You use this command only if the specified PGU is set to VPULse mode (not V) by
the :PAGE:CHAN:PGU<n>:MODE command.
At *RST, this value is 0.
:PAGE:MEASure:PGUSetup:PULSe:PGU<n>:BASE base | MINimum |
MAXimum
Parameter Type
base numeric
base <newline><^END>
base is NR3 response data type.
OUTPUT @Hp4155;":PAGE:MEAS:PGUS:PULS:PGU1:BASE 1"
OUTPUT @Hp4155;":PAGE:MEAS:PGUS:PULS:PGU1:BASE MIN"
OUTPUT @Hp4155;":PAGE:MEAS:PGUS:PULS:PGU1:BASE?"
ENTER @Hp4155;A
OUTPUT @Hp4155;":PAGE:MEAS:PGUS:PULS:PGU1:BASE? MIN"
ENTER @Hp4155;A
Agilent 4155C/4156C SCPI Command Reference, Edition 1
:PAGE:MEASure:PGUSetup:PULSe:PGU<n>:BASE
-40 to 40 V
SCPI Commands
Explanation
5-179