Snmp-Server Host - Dell Catalyst 3130 Command Reference Manual

Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands

snmp-server host

Use the snmp-server host global configuration command on the switch stack or on a standalone switch to
specify the recipient (host) of a Simple Network Management Protocol (SNMP) notification operation.
Use the no form of this command to remove the specified host.
Syntax Description host-addr
udp-port port
informs | traps
version 1 | 2c | 3
vrf vrf-instance
OL-12248-03
snmp-server host host-addr [informs | traps] [version {1 | 2c | 3 {auth | noauth| priv}] [vrf
vrf-instance] {community-string [notification-type]}
no snmp-server host host-addr [informs | traps] [version {1 | 2c | 3 {auth | noauth | priv}] [vrf
vrf-instance] community-string
Name or Internet address of the host (the targeted recipient).
(Optional) Configure the User Datagram Protocol (UDP) port number of the
host to receive the traps. The range is 0 to 65535.
(Optional) Send SNMP traps or informs to this host.
(Optional) Version of the SNMP used to send the traps.
These keywords are supported:
1—SNMPv1. This option is not available with informs.
2c—SNMPv2C.
3—SNMPv3. These optional keywords can follow the Version 3 keyword:
•
•
•
Note
(Optional) Virtual private network (VPN) routing instance and name for this
host.
auth (Optional). Enables Message Digest 5 (MD5) and Secure Hash
Algorithm (SHA) packet authentication.
noauth (Default). The noAuthNoPriv security level. This is the default
if the [auth | noauth | priv] keyword choice is not specified.
priv (Optional). Enables Data Encryption Standard (DES) packet
encryption (also called privacy).
The priv keyword is available only when the cryptographic
(encrypted) software image is installed.
Cisco Catalyst Blade Switch 3120 for HP Command Reference
snmp-server host
2-697