Snmp-Server Host - Dell S4810 Reference Manual

Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version
8.3.10.2
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Usage The following Example specifies the group named harig as a version 3 user
Information requiring both authentication and encryption and read access limited to the read
named rview.
Example
Dell#conf
Dell(conf)# snmp-server group harig 3 priv read rview
Dell#
Related
show snmp group
Commands
storage type of each group.
show running-config

snmp-server host

Configure the recipient of an SNMP trap operation.
S4810
Syntax
snmp-server host ip-address | ipv6-address [vrf vrf-name] traps
| informs [version 1 | 2c | 3] [auth | no auth | priv]
[community-string] [udp-port port-number] [notification-type]
Simple Network Management Protocol (SNMP) and Syslog
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for the access parameter.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
NOTE: The number of configurable groups is limited to 16 groups.
— displays the group name, security model, view status, and
— displays the SNMP running configuration.
1567