Ip Directed-Broadcast - Dell C9000 Series Reference Manual

Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
Usage Information You must be in INTERFACE mode before you add an IP address to an interface. Assign
an IP address to an interface prior to entering ROUTER OSPF mode.

ip directed-broadcast

Enable the interface to receive directed broadcast packets.
C9000 Series
Syntax
ip directed-broadcast
To disable the interface from receiving directed broadcast packets, use the no ip
directed-broadcast command.
Defaults Disabled (that is, the interface does not receive directed broadcast packets)
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
IPv4 Routing 1188