Configure Sflow Poll-Interval - Extreme Networks ExtremeWare Command Reference Manual

configure sflow poll-interval

configure sflow poll-interval <seconds>
Description
Configures the sFlow counter polling interval at which the statistics counter values are sent to the sFlow
collector.
NOTE
This command is available only on the "i" series switches.
Syntax Description
seconds Specifies the number of seconds between polling each counter. The value can range from 1 to 3600
seconds.
Default
The default polling interval is 20 seconds.
Usage Guidelines
Each sFlow statistics counter is polled at regular intervals, and this data is then sent to the sFlow
collector. This command is used to set the polling interval. The same value is used for all data sources.
The polling interval applies to each counter separately, and the polling is distributed among the
counters. For example, if the polling interval is 20 seconds and there are two counters, data is collected
alternately every 10 seconds.
Example
The following command sets the polling interval to 60 seconds:
configure sflow poll-interval 60
History
This command was first available in ExtremeWare 7.3.0.
Platform Availability
This command is available only on the "i" series platforms.
ExtremeWare 7.5 Command Reference Guide
configure sflow poll-interval
703