Extreme Networks ExtremeWare Command Reference Manual page 345

Field
Secondary ExtremeWare Version Stacked Switches only:
Image Selected
Image Booted
Configuration Selected
Configuration Booted
Primary Configuration
Secondary Configuration
Configured Type
Inline Power
UTP Ports Available
• Link Active
• Link Down
• GBIC Missing
If you do not specify a slot number, information for all slots is displayed.
For ARM, ATM, MPLS, PoS and WAN (E1, T1, and T3) modules: The ExtremeWare technology
release that supports these modules includes multiple software packages. One software package runs on
the MSM or SMMi module while another package runs on each ARM, ATM, MPLS, PoS, or WAN
module. You must download the software packages independently using the ExtremeWare
command. Each software package has an associated version number that you can display using
image
the
show version
and the ARM, ATM, MPLS, PoS, or WAN module software package be the same version.
For ARM, ATM, MPLS and PoS modules: To ensure compatibility, the MSM performs an automatic
compatibility check before a ARM, ATM, MPLS or PoS module is activated. If the versions of the
software packages are incompatible, the ARM, ATM, MPLS or PoS ports on the module will not come
up and the
show slot
module is incompatible with ExtremeWare.
Assuming the ARM, ATM, MPLS or PoS module has no problems, the command
(where "<slot>" is the number of the slot where you installed the module) displays that ExtremeWare
has detected the module and set it to the OPERATIONAL state.
As the module progresses through its initialization, the
general purpose processor (GPP) subsystem change state to OPERATIONAL, and then each of the
network processors will change state to OPERATIONAL.
ExtremeWare 7.5 Command Reference Guide
Description
ExtremeWare version of the secondary software image.
Stacked Switches only:
The image selected on the switch.
Stacked Switches only:
The running image of the switch.
Stacked Switches only:
The configuration selected for the switch.
Stacked Switches only:
The configuration that is active.
Stacked Switches only:
The configuration saved as primary.
Stacked Switches only:
The configuration saved as secondary.
The model number as configured by the user. This field is used to detect the
mismatches between the configured and actual model number.
Power consumption.
Displays a list of ports. On stacked switches, the stacking ports are enclosed
in brackets. Port numbers with active and down links are listed.
command. It is recommended (not required), that the ExtremeWare software package
command will indicate that the software on the ARM, ATM, MPLS or PoS
command displays the
show slot <slot>
show slot
download
show slot <slot>
345