Configure Debug-Trace Npcard - Extreme Networks ExtremeWare Command Reference Manual

Troubleshooting Commands

configure debug-trace npcard

configure debug-trace npcard <debug level>
Description
This command enables system-level debug tracing for the MPLS, PoS, ARM, and ATM modules.
NOTE
This command is available only on the MPLS, PoS, ARM, and ATM modules for the "i" series switches.
Syntax Description
debug level Specifies a debug level:
0— Indicates that a severe event has occurred that most likely will result in the termination or
improper operation of the ARM.
1— Indicates that a major event has occurred. It may represent a negative operation. It should
be reviewed to ensure proper continuation of ARM operation.
2— Indicates a minor event has occurred.
3— Provides additional information to support engineers for the purpose of diagnosing network
problems.
4 — No additional information recorded.
5 — No additional information recorded.
Default
The default level is 0.
Usage Guidelines
The range is 1 to 5. Higher levels record more verbose messages. Higher levels also record
debug level
the messages recorded at lower levels.
Example
The following command sets the reporting level for module errors to 3:
configure debug-trace npcard 3
History
This command was first available in an ExtremeWare IP Technology Services Release based on
ExtremeWare v6.1.8b12.
Platform Availability
This command is available on the MPLS, PoS, ARM, and ATM modules.
1170 ExtremeWare 7.5 Command Reference Guide