Configure Debug-Trace Wireless - Extreme Networks ExtremeWare Command Reference Manual

configure debug-trace wireless

configure debug-trace wireless ports [<portlist> | all] [dot1x | radius |
mac | snmp | wlan-driver | eth-driver | ap-scan | client-diag | mac-radius
| wpa-wpa2 | iapp] <debug-level>
Description
Enables debug tracing for troubleshooting.
Syntax Description
portlist
all
dot1x
radius
mac
snmp
wlan-driver
eth-drive
ap-scan
client-diag
mac-radius
wpa-wpa2
iapp
debug-level
Default
Disabled
Usage Guidelines
Use to trace messages for troubleshooting.
Example
The following example enables debug tracing for IAPP on port 1:15 with a debug level of 2:
configure debug-trace wireless ports 1:15 iapp 2
History
This command was first available in ExtremeWare 7.3e.
ExtremeWare 7.5 Command Reference Guide
Specifies one or more ports or slots and ports. Can be one or more port numbers. May be in the
form 1, 2, 1:2, 3-5, 2:*, 2:5, 2:6-2:8.
Specifies all ports.
Configures debug tracing level for the 802.1x activity.
Configures debug tracing level for the RADIUS activity.
Configures debug tracing level for the MAC layer activity.
Configures debug tracing level for the SNMP activity.
Configures debug tracing level for the WLAN driver activity.
Configures debug tracing level for the Ethernet driver activity.
Configures debug tracing level for the Access Point Scans.
Configures debug tracing level for the Client Diagnostics.
Configures debug tracing level for the MAC-RADIUS activity.
Configures debug tracing level for the WPA and WPA2 activities.
Configures debug tracing level for the IAPP activity.
Specifies a debug level. The default is 0 (off).
configure debug-trace wireless
1195