Configure Debug-Trace Accounting - Extreme Networks ExtremeWare Command Reference Manual

configure debug-trace accounting

configure debug-trace accounting <debug level>
Description
This command provides system-level debug tracing for the accounting subsystem.
NOTE
This command is available on the ARM and MPLS modules on the BlackDiamond switches and on the
"e" series switches.
Syntax Description
debug level
Default
The default level is 0.
Usage Guidelines
The
debug level
the messages recorded at lower levels.
Example
The following command sets the reporting level for accounting to 3:
configure debug-trace accounting 3
Following is the log output at this level for switches in the "i" series:
<DBUG:NPAPI> Slot6 NP_KRT_GET_DSB_COUNTS responses from both NPs
<DBUG:NPAPI> Slot6 genpipe: received DSA message GET_COUNTS
<DBUG:DSA> processDSBMessage: rsp type 2 from slot 6
<DBUG:DSA> (npGenPipe)sendMsg: 0x8093f70c sends to slot 5, len=68
<DBUG:DSA> npGenPipeAllocTCB: TCB allocated by Accounting (DSB)(Accounting)
<DBUG:DSA> Vlan vlan1 Vlan ID 4091
<DBUG:DSA> processDSBMessage: rsp type 2 from slot 6
<DBUG:DSA> (npGenPipe)sendMsg: 0x8093f70c sends to slot 5, len=68
<DBUG:DSA> npGenPipeAllocTCB: TCB allocated by Accounting (DSB)(Accounting)
<DBUG:DSA> Vlan vlan0 Vlan ID 4092
<DBUG:DSA> processDSBMessage: rsp type 2 from slot 6
ExtremeWare 7.5 Command Reference Guide
Specifies a debug level:
0 — Records critical error messages, such as memory allocation errors. Indicates a severe event
that can terminate or corrupt accounting.
1 — Records warning messages for various non-critical error conditions.
2 — Records various informational messages.
3 — Records debug information, such as message and event processing. Provides additional
information to support engineers for the purpose of diagnosing network problems.
4 — No additional information recorded.
5 — No additional information recorded.
range is 0 to 5. Higher levels record more verbose messages. Higher levels also record
configure debug-trace accounting
1125