Extreme Networks ExtremeWare Command Reference Manual page 799

• Received Byte Count (RX Byte Count)—The total number of bytes that were received by the port,
including bad or lost frames. This number includes bytes contained in the Frame Check Sequence
(FCS), but excludes bytes in the preamble.
• Received Broadcast (RX Bcast)—The total number of frames received by the port that are addressed
to a broadcast address.
• Received Multicast (RX Mcast)—The total number of frames received by the port that are addressed
to a multicast address.
For version 2.0 and 4.0
• Disabled and Not Present are not available as link status indicators.
• Chassis is available as a link status indicator. If chassis is listed, the link is connected to a Summit
Virtual Chassis.
Examples
The following command displays port statistics for ports 1 through 3 on a stand-alone switch:
show ports 1-3 stats
The following command displays port statistics for slot 1, ports 1 through 3 on a modular switch:
show ports 1:1-1:3 stats
The following command displays port statistics for all ports:
show ports stats
The output produced by the
Port Statistics
Port
================================================================================
1:1
1:2
1:3
1:4
1:5
1:6
1:7
1:8
The following command displays cable diagnostics information for all ports:
show ports stats cable-diagnostics
The output produced by the
following:
Port Statistics
Port
================================================================================
1:1
1:2
1:3
1:4
ExtremeWare 7.5 Command Reference Guide
show ports stats
Link Tx Pkt Tx Byte
Status Count Count
A 740131 61671211
A 292131 24686533
A 37273 4351318
R 0 0
R 0 0
A 1099 375858
R 0 0
A 1099 375858
show ports stats cable-diagnostics
Link Num
Status Diags
A 0
A 1
A 0
R 0
command is similar to the following:
Thu Jul 8 09:50:50 2004
Rx Pkt Rx Byte
Count Count
201310 17023242
896516 183343391
37578 4721313
0 0
0 0
11962 901306
0 0
0 0
Thu Jul 8 09:52:19 2004
Diags Diags
Success Fail
0 0
1 0
0 0
0 0
show ports stats
Rx Rx
Bcast Mcast
7 3963
37 21456
36 21551
0 0
0 0
4421 7541
0 0
0 0
command is similar to the
Diags
Change
0
0
0
0
799