Configure Ports Auto-Polarity - Extreme Networks ExtremeWare Command Reference Manual

Commands for Configuring Slots and Ports on a Switch

configure ports auto-polarity

configure ports [<portlist> | all] auto-polarity [off | on]
Description
Configures the autopolarity detection feature on the specified Ethernet ports.
Syntax Description
portlist Specifies one or more ports on the switch. May be in the form 1, 2, 3-5.
all Specifies all of the ports on the switch.
off Disables the autopolarity detection feature on the specified ports.
on Enables the autopolarity detection feature on the specified ports.
Default
The autopolarity detection feature is on.
Usage Guidelines
Use the keyword to enable or disable the autopolarity detection feature on all of the Ethernet ports.
all
When autopolarity is disabled on one or more Ethernet ports, you can verify that status by using the
command:
show configuration
This command will list the ports for which the feature has been disabled.
To verify the current autopolarity status, use the
name>} info {detail}
Example
The following command disables the autopolarity detection feature on ports 3-5 on a Summit 200
switch:
configure ports 3-5 auto off
The following command enables the autopolarity detection feature on ports 3-5 on the Summit48si
switch:
configure ports 3-5 auto-polarity on
History
This command was first available in ExtremeWare 6.2.2b108.
Platform Availability
This command is available on all platforms.
270
show ports {mgmt | <portlist>| vlan <vlan
command.
ExtremeWare 7.5 Command Reference Guide