Enable Log Debug-Mode - Extreme Networks ExtremeWare Command Reference Manual

Hide thumbs Also See for ExtremeWare:

Table of Contents

Commands for Status Monitoring and Statistics

enable log debug-mode

Enables debug mode. The switch allows debug events included in log filters to be logged.

Syntax Description

This command has no arguments or variables.

Usage Guidelines

This command enables debug mode. Debug mode must be enabled prior to logging debug messages,

which can severely degrade performance. For typical network device monitoring, debug mode should

remain disabled, the default setting. Debug mode should only be enabled when advised by technical

support, or when advanced diagnosis is required. The debug mode setting is saved to FLASH.

The following command enables debug mode:

enable log debug-mode

This command was first available in ExtremeWare 7.1.0.

This command was added to the Summit "e" series of switches in ExtremeWare 7.2e.

Platform Availability

This command is available on all platforms.

ExtremeWare 7.5 Command Reference Guide

Extremeware 7.5