Configure Nat Delete - Extreme Networks ExtremeWare Command Reference Manual

configure nat delete

configure nat delete [all |
vlan <vlan name> map source [any | <source_ip address>/<mask>]
{l4-port [any | <port> {- <port>}]}
{destination <dest_ip address>/<mask> {l4-port [any | <port> {- <port>}]}}
to <nat_ip address> [/<mask> | - <ip address>]
[tcp | udp | both] [portmap {<min> - <max>} | auto-constrain]
Description
Deletes a NAT translation rule.
Syntax Description
all
vlan name
source_ipaddress/mask
l4-port
port
dest_ipaddress/mask
nat_ipaddress
tcp
udp
both
min
max
autoconstrain
Default
N/A
Usage Guidelines
To delete all NAT rules, use the
same parameters that were used to create the rule.
ExtremeWare 7.5 Command Reference Guide
Specifies that all NAT rules should be deleted.
Specifies the name of the outside VLAN to which this rule applies.
Specifies a subnet IP address (in the format x.x.x.x/mask where mask is the number
of bits in the subnet mask) that defines the source of the traffic to be mapped.
Specifies a layer 4 port or port range. When used with a source IP address, indicates
that the rule applies only to traffic from the specified layer 4 port(s).
When used with a destination IP address, indicates that the rule applies only to
packets with the specified layer 4 port(s) as their destination.
Specifies a port number in the range 1 to 65535.
any indicates that the rule should be applied to traffic to or from any layer 4 port.
Specifies a subnet IP address (in the format x.x.x.x/mask where mask is the number
of bits in the subnet mask) used to determine the packets to which this rule applies.
Specifies an IP address for the outside VLAN to which the source IP addresses will
be mapped. This can be specified as a subnet (IP address and mask) or as an
address range.
Specifies only TCP traffic should be translated.
Specifies only UDP traffic should be translated.
Specifies that both TCP and UDP traffic should be translated.
Specifies a port number in the range 1 to 65535. The default setting is 1024.
Specifies a port number in the range 1 to 65535. The default setting is 65535.
Specifies that each inside IP address should be restricted in the number of
simultaneous connections.
keyword. To delete a specific NAT rule, you must use exactly the
all
configure nat delete
477