Disable Netlogin - Extreme Networks ExtremeWare Command Reference Manual

disable netlogin

disable netlogin [web-based |dot1x |mac]
Description
Disables network login modes.
Syntax Description
web-based
dot1x
mac
Default
Web-based and 802.1x authentication are enabled by default.
MAC-based authentication is disabled by default.
Usage Guidelines
All types, any combination of types, or no type of authentication can be enabled on the same switch. To
enable an authentication mode, use the following command:
enable netlogin [web-based | dot1x |mac]
This command was first introduced as
network login, the web-based mode. The original command was subsequently deprecated when the
802.1x mode of network login was introduced in ExtremeWare 7.1.0. The deprecated version of the
command is temporarily supported in configurations. During an upgrade, the deprecated command
disable netlogin
disable netlogin web-based
disable netlogin dot1x
Example
The following command disables web-based authentication for network login:
disable netlogin web-based
The following command globally disables MAC-based RADIUS authentication for network login:
disable netlogin mac
History
This command was first available in ExtremeWare 7.0.0.
The
web-based
command (without the new keywords) was deprecated.
This command was added to the Summit "e" series of switches in ExtremeWare 7.1e.
ExtremeWare 7.5 Command Reference Guide
Specifies web-based authentication.
Specifies 802.1x authenticating.
Specifies MAC-based RADIUS authentication.
disable netlogin
will be interpreted as:
and keywords were added in ExtremeWare 7.1.0, and the initial version of the
dot1x
, which disabled the initial version of
disable netlogin
969