Configure Vlan Add Member-Vlan - Extreme Networks ExtremeWare Command Reference Manual

Hide thumbs Also See for ExtremeWare:

Table of Contents

VLAN Commands

configure vlan add member-vlan

configure vlan <translation vlan name> add member-vlan <vlan name>

Adds a member VLAN to a translation VLAN.

This command is available only on the "i" series switches.

Syntax Description

translation vlan name

Specifies a translation VLAN.

Specifies a VLAN to add to the translation VLAN.

Usage Guidelines

This command adds a member VLAN to a translation VLAN. The 802.1Q tags for member VLANs are

translated to the single tag of the translation VLAN. Then the layer 2 traffic from the member VLANs is

carried by a single VLAN, improving VLAN scaling.

Traffic is switched locally between client devices on the same member VLANs, just as on normal

VLANs. Traffic cannot be switched between clients on separate member VLANs. Traffic from any

member VLAN destined for the translation VLAN is switched and the VLAN tag is translated

appropriately. Traffic from the translation VLAN destined for any member VLAN is switched and the

VLAN tag is translated.

The added VLAN cannot have an IP address configured or already be a member VLAN or a translation

VLAN; it must contain only "i" series module Ethernet ports. In addition, ESRP, Network Login, or

DHCP cannot be enabled on any ports belonging to either the member VLAN or the translation VLAN.

The following command adds the member VLAN named v101 to the translation VLAN named v1000:

configure vlan v1000 add member-vlan v101

This command was first available in ExtremeWare 7.1.0.

Platform Availability

This command is available only on the "i" series platforms.

ExtremeWare 7.5 Command Reference Guide

Extremeware 7.5