Configure Dot1P Type - Extreme Networks ExtremeWare Command Reference Manual

QoS Commands

configure dot1p type

configure dot1p type <dot1p_priority> qosprofile <qosprofile>
Description
Configures the default QoS profile to 802.1p priority mapping.
NOTE
This command is available only on the "i" series switches.
Syntax Description
dot1p_priority Specifies the 802.1p priority value. The value is an integer between 0 and 7.
qosprofile Specifies a QoS profile.
Default
N/A
Usage Guidelines
An 802.1p priority value seen on ingress can be mapped to a particular QoS profile and with specific
bandwidth management and priority behavior.
The default mapping of each 802.1p priority value to QoS profile is described in Table 12.
Table 12: 802.1p Priority Value-to-QoS Profile Default Mapping
Priority Value QoS Profile Summit Chipset QoS Profile "i" Chipset
0 Qp1
1
2 Qp2
3
4 Qp3
5
6 Qp4
7
Example
The following commands swap the QoS profiles associated with 802.1p priority values 1 and 2 on an
"i" series device:
configure dot1p type 2 qosprofile qp2
configure dot1p type 1 qosprofile qp3
History
This command was available in ExtremeWare 6.0.
436
Qp1
Qp2
Qp3
Qp4
Qp5
Qp6
Qp7
Qp8
ExtremeWare 7.5 Command Reference Guide