Configure Radius Server - Extreme Networks ExtremeWare Command Reference Manual

Security Commands

configure radius server

For the "i" series switches:
configure radius [primary | secondary] server [<ipaddress> | <hostname>]
{<L4 port no>} client-ip [<ipaddress>]
For the "e" series switches:
configure radius [primary | secondary] server [<ipaddress> | <hostname>]
client-ip [<ipaddress>]
Description
Configures the primary and secondary RADIUS authentication server.
Syntax Description
primary Configures the primary RADIUS authentication server.
secondary Configures the secondary RADIUS authentication server.
ipaddress IP address of the server being configured.
hostname Host name of the server being configured. Must be able to be resolved to an IP address.
ipaddress IP address used by the switch to identify itself when communicating with the RADIUS authentication
server.
L4 port no L4 port used to contact the RADIUS server.
NOTE: This option is available only on the "i" series switches.
Default
The default UDP port setting is 1645.
Usage Guidelines
Use this command to specify RADIUS server information. You can configure up to two primary and
two secondary RADIUS authentication servers.
Use of the parameter requires that DNS be enabled.
hostname
The RADIUS server defined by this command is used for user name authentication and CLI command
authentication.
Example
The following command configures the primary RADIUS server on host radius1 using the default UDP
port (1645) for use by the RADIUS client on switch 10.10.20.30:
configure radius primary server radius1 client-ip 10.10.20.30
History
This command was first available in ExtremeWare 4.1.
This command was added to the Summit "e" series of switches in ExtremeWare 7.1e.
870 ExtremeWare 7.5 Command Reference Guide