Configure Nat Finrst-Timeout - Extreme Networks ExtremeWare Command Reference Manual

configure nat finrst-timeout

configure nat finrst-timeout
configure nat finrst-timeout <seconds>
Description
Configures the timeout for a TCP session that has been torn down or reset.
Syntax Description
seconds Specifies the number of seconds to wait before the session table entry times out.
Default
Default timeout is 60 seconds.
Usage Guidelines
Setting the timeout to zero specifies that session table entries should not be timed out. This setting is not
normally recommended, because NAT resources will be used up.
Example
The following command configures the timeout for a reset or torn down TCP session to 120 seconds:
configure nat finrst-timeout 120
History
This command was first available in ExtremeWare 6.2.
This command was added to the Summit "e" series of switches in ExtremeWare 7.1e.
Platform Availability
This command is available on all platforms.
ExtremeWare 7.5 Command Reference Guide 479