Configure Sflow Collector - Extreme Networks ExtremeWare Command Reference Manual

configure sflow collector

configure sflow collector <ip-address> port <udp-port>
Description
Configures the IP address and UDP port number identifying the sFlow collector.
NOTE
This command is available only on the "i" series switches.
Syntax Description
ip-address
udp-port
Default
The default UDP port number is 6343
Usage Guidelines
This command allows you to configure where to send the sFlow data. You must specify an IP address
for the sFlow data collector, and a UDP port where the samples will be transmitted to and from the
sFlow agent.
You can configure up to four sFlow collectors. Each unique combination of an IP address and a UDP
port identifies a collector.
Using the
unconfigure sflow collector
NOTE
The notation
Example
The following command specifies that the sFlow agent will send all samples to the collector with the
address 123.123.123.123 and port number 9876:
configure sflow collector 123.123.123.123 port 9876
or
configure sflow collector 123.123.123.123:9876
History
This command was first available in ExtremeWare 7.3.0.
ExtremeWare 7.5 Command Reference Guide
Specifies the IP address to send the sFlow data.
Specifies the UDP port number to send the sFlow data.
can be used instead of
:
command resets the collector parameters to the default.
, as in the examples.
port
configure sflow collector
701