Extreme Networks ExtremeWare Command Reference Manual page 767

Hide thumbs Also See for ExtremeWare:

Table of Contents

For ExtremeWare 6.2.2b108:

The default for the transceiver test is enabled. The test is enabled two minutes after the switch boots or

immediately after you enable the test.

For ExtremeWare 6.2.2b134 and ExtremeWare 7.1.0:

The default for the transceiver test is disabled. If you load your saved ExtremeWare 6.2.2b108

configurations onto a switch with ExtremeWare 6.2.2b134 or ExtremeWare 7.1.0 or later, the transceiver

test is enabled. You must manually disable the transceiver test if you want the feature disabled.

The following command enables the transceiver test on slot 4 of a modular switch:

enable transceiver-test slot 4

This command was first available in ExtremeWare 6.2.2b108.

The default for this command was changed to disabled in ExtremeWare 6.2.2b134.

This command was not supported in ExtremeWare 7.0.

This command is supported in ExtremeWare 7.1.0.

Platform Availability

This command is available only on modular switches.

ExtremeWare 7.5 Command Reference Guide

Operational MAC

Operational UART

Operational FLASH

Operational SRAM

Operational NVRAM

Operational ENET

Operational QUAKE

Operational TWISTER

enable transceiver-test

Extremeware 7.5