Configure Nat Syn-Timeout - Extreme Networks ExtremeWare Command Reference Manual

configure nat syn-timeout

configure nat syn-timeout
configure nat syn-timeout <seconds>
Description
Configures the timeout for an entry with an unacknowledged TCP SYN state.
Syntax Description
seconds Specifies the number of seconds to wait before the session table entry times out.
Default
Default timeout is 60 seconds.
Usage Guidelines
Setting the timeout to zero specifies that session table entries should not be timed out. This setting is not
normally recommended, because NAT resources will be used up.
Example
The following command configures the timeout for a session with an unacknowledged SYN packet to
120 seconds:
configure nat syn-timeout 120
History
This command was first available in ExtremeWare 6.2.
This command was added to the Summit "e" series of switches in ExtremeWare 7.1e.
Platform Availability
This command is available on all platforms.
ExtremeWare 7.5 Command Reference Guide 481