Extreme Networks ExtremeWare Command Reference Manual page 331

(D) Port Disabled, (dy) Dynamic Load Sharing
(e) Extreme Discovery Protocol Enabled, (E) Port Enabled
(f) Flooding Enabled, (g) Egress TOS Enabled, (G) SLB GoGo Mode
(h) Hardware Redundant Phy, (j) Jumbo Frame Enabled
(l) Load Sharing Enabled, (m) MAC Learning Enabled
(n) Ingress TOS Enabled, (o) Dot1p Vlan Priority Replacement Enabled
(p) Load Sharing Algorithm port-based, (P) Software Primary Port
(q) Background QOS Monitoring Enabled
(r) Load Sharing Algorithm round-robin, (R) Software Redundant Port
Diag: (P) Passed, (F) Failed
Port: (iL) Internal Loopback
The following command displays more specific information for slot 2, port 6 in a modular switch:
show ports 2:6 info detail
Following is sample output from this command:
Port 2:6:
Type:
Diagnostic:
Random Early Drop: Disabled
Admin state:
Link state:
Link counter:
VLAN cfg:
Default [Internal Tag=0001,Mac-Limit:Cfg=No-limit,LRN=0,BlkHole=0]
STP cfg:
Aggregate B/W: Configured [ 25]%
Trunking:
Protocol:
EDP:
DLCS:
lbdetect:
Learning:
Flooding:
Jumbo:
BG QoS monitor: disabled
Ingress Rate Shaping:
QoS profile:
Queue:
Ingress IPTOS:
ExtremeWare 7.5 Command Reference Guide
UTP
passed
Enabled, with auto-duplex auto-speed sensing
Ready
Up 0 time(s), Down 0 times(s)
s0(disable), Tag=(none), Mode=802.1D, State=FORWARDING
Load sharing is not enabled
VLAN=Default
enabled
disabled
disabled
enabled
disabled
Disabled
None configured
Q0 using QP1 MinBw=0%
Q1 using QP2 MinBw=0%
Q2 using QP3 MinBw=0%
Q3 using QP4 MinBw=0%
Q4 using QP5 MinBw=0%
Q5 using QP6 MinBw=0%
Q6 using QP7 MinBw=0%
Q7 using QP8 MinBw=0%
Examination is disabled
IPTOS->QOSProfile mapping:
00->QP1 01->QP1 02->QP1 03->QP1 04->QP1 05->QP1 06->QP1 07->QP1
08->QP2 09->QP2 10->QP2 11->QP2 12->QP2 13->QP2 14->QP2 15->QP2
Vpri=0 Protocol=ANY [EtherType:ffff]
MaxBw=100% Pri=0.
MaxBw=100% Pri=1.
MaxBw=100% Pri=2.
MaxBw=100% Pri=3.
MaxBw=100% Pri=4.
MaxBw=100% Pri=5.
MaxBw=100% Pri=6.
MaxBw=100% Pri=7.
show ports info
331