Configure Transceiver-Test Period - Extreme Networks ExtremeWare Command Reference Manual

Commands for Status Monitoring and Statistics

configure transceiver-test period

configure transceiver-test period <period <1-60>>
Description
Configures how often the switch runs the transceiver test.
NOTE
This command is available only on modular switches.
Syntax Description
period <1-60> Specifies, in seconds, how often the transceiver test runs. The range is 1 to 60.
Default
12 seconds
Usage Guidelines
Use this feature when the switch can be brought off-line.
Configuring the transceiver test period to 11 seconds or less can affect system performance; therefore,
Extreme Networks does not recommend changing the default transceiver test period. The default is
adequate for most networks.
Example
The following command configures the transceiver test to run every 15 seconds:
configure transceiver-test period 15
History
This command was first available in ExtremeWare 6.2.2b108.
This command was not supported in ExtremeWare 7.0.
This command is supported in ExtremeWare 7.1.0.
Platform Availability
This command is available only on modular switches.
720 ExtremeWare 7.5 Command Reference Guide