Configure Vlan Access-Profile - Extreme Networks ExtremeWare Command Reference Manual

Security Commands

configure vlan access-profile

configure vlan <vlan name> access-profile [<access profile> | none]
Description
Configures a BlackDiamond 6800 series switch running ExtremeWare 4.1 to control the routing of traffic
between VLANs.
NOTE
This command is available only on the BlackDiamond 6800 series switches.
Syntax Description
vlan name Specifies the name of an egress VLAN.
access profile Specifies an access profile that contains a list of ingress VLANs.
none Specifies that no access profile should be associated with this VLAN.
Default
N/A
Usage Guidelines
This command configures a BlackDiamond 6800 series switch to permit or deny the routing of IP traffic
from the specified list of ingress VLANs to the specified egress VLAN. If the access profile uses permit
mode, only traffic from the VLANs specified in the access profile will be routed to egress VLANs
configured to use that access profile.
The VLAN must already exist. The access profile must be of type VLAN (supported only in
ExtremeWare releases 4.0 and earlier).
Example
Given an access profile created and configured as follows:
create access-profile okprofile vlan
configure access-profile okprofile mode permit
configure access-profile okprofile add vlan exec
The following command permits traffic from VLAN exec to be routed to VLAN vlan1:
configure vlan vlan1 access-profile okprofile
History
This command was available in ExtremeWare 4.1.
Support for this command was discontinued in ExtremeWare 6.0.
922 ExtremeWare 7.5 Command Reference Guide