Configure Transceiver-Test Threshold - Extreme Networks ExtremeWare Command Reference Manual
Version 7.5
Hide thumbs
Also See for ExtremeWare:
- Command reference manual (2620 pages) ,
- Command reference manual (2254 pages) ,
- Command reference manual (1598 pages)
Table of Contents
Advertisement
configure transceiver-test threshold
configure transceiver-test threshold
configure transceiver-test threshold <1-8>
Description
Configures the number of errors the switch accepts before an action is taken.
NOTE
This command is available only on modular switches.
Syntax Description
threshold
Specifies the number of errors. The range is 1 to 8 errors.
Default
Three errors
Usage Guidelines
Use this feature when the switch can be brought off line.
Extreme Networks does not recommend changing the default transceiver test threshold parameter. The
default parameter is adequate for most networks.
Example
The following command configures the switch to accept 4 errors before an action is taken:
configure transceiver-test threshold 4
History
This command was first available in ExtremeWare 6.2.2b108.
This command was not supported in ExtremeWare 7.0.
This command is supported in ExtremeWare 7.1.0.
Platform Availability
This command is available only on modular switches.
ExtremeWare 7.5 Command Reference Guide
721
Advertisement
Table of Contents
