Configure Debug-Trace Rip-Triggered-Update - Extreme Networks ExtremeWare Command Reference Manual

configure debug-trace rip-triggered-update

configure debug-trace rip-triggered-update <debug level> vlan <vlan name |
all>
Description
This command records debug information to the syslog.
Syntax Description
debug level
vlan name
all
Default
The default level is 0.
Usage Guidelines
The
debug level
the messages recorded at lower levels.
Example
The following command sets the reporting level for RIP triggered update errors to 3:
configure debug-trace rip-triggered-update 3
Following is the log output at this level:
<DBUG:RIP > Suppressing triggered updates for 1 secs.
<INFO:SYST> msm-a-console admin: enable rip
<INFO:SYST> msm-a-console admin: disable rip
History
This command was first available in ExtremeWare 6.1.
This command was added to the Summit "e" series of switches in ExtremeWare 7.2e.
Platform Availability
This command is available on all platforms.
ExtremeWare 7.5 Command Reference Guide
Specifies a debug level:
0 — None.
1 — None.
2 — None.
3 — Records that the switch is suppressing triggered updates for x seconds.
4 — No additional information recorded.
5 — No additional information recorded.
Specifies a VLAN name.
Specifies all VLANs.
range is 0 to 5. Higher levels record more verbose messages. Higher levels also record
configure debug-trace rip-triggered-update
1183