Configure Debug-Trace Mpls-Signalling - Extreme Networks ExtremeWare Command Reference Manual

Troubleshooting Commands

configure debug-trace mpls-signalling

configure debug-trace mpls-signalling <level>
Description
This command records debug information to the syslog.
NOTE
This command is available only on the MPLS module for the "i" series switches.
Syntax Description
debug level Specifies a debug level:
0 — None.
1 — Records peer interface state msgs.
2 — No additional information recorded.
3 — Records finite state machine events
4 — No additional information recorded.
5 — Records MPLS signalling packets, such as hello packets and label mappings.
Default
The default level is 1.
Usage Guidelines
The range is 1 to 5. Higher levels record more verbose messages. Higher levels also record
debug level
the messages recorded at lower levels.
Example
The following command sets the reporting level for MPLS signalling subsystem errors to 1:
configure debug-trace mpls-signalling 1
Following is the log output at this level:
<DBUG:IPHS> last message repeated 3 times
<DBUG:IPHS> Skipping FDB refresh for 10.3.1.1 due to LSP
<DBUG:IPHS> last message repeated 3 times
<DBUG:IPHS> Skipping FDB refresh for 10.3.1.1 due to LSP
<DBUG:IPHS> last message repeated 3 times
<DBUG:IPHS> Skipping FDB refresh for 10.3.1.1 due to LSP
<DBUG:IPHS> last message repeated 3 times
<DBUG:IPHS> Skipping FDB refresh for 10.3.1.1 due to LSP
<DBUG:IPHS> last message repeated 3 times
<DBUG:IPHS> Skipping FDB refresh for 10.3.1.1 due to LSP
<INFO:SYST> User admin logged out from telnet (100.100.105.1)
<INFO:USER> admin logged in through telnet (100.100.105.1)
<DBUG:IPHS> Skipping FDB refresh for 10.3.1.1 due to LSP
1168 ExtremeWare 7.5 Command Reference Guide