Create Access-List Udp Destination Source Ports - Extreme Networks ExtremeWare Command Reference Manual

create access-list udp destination source ports

create access-list <name> udp destination [<dest_ipaddress>/<mask> | any]
ip-port [<dst_port> | range <dst_port_min> <dst_port_max> | any]
source [<src_ipaddress>/<src_mask> | any] ip-port [<src_port> | range
<src_port_min> <src_port_max> | any] [permit <qosprofile> | deny] ports
[<portlist> | any] {precedence <prec_number>}
Description
Creates a named IP access list that applies to UDP traffic.
NOTE
This command is available only on the "i" series switches. To create an access list for an "e" series
switch, use the
Syntax Description
name
dest_ipaddress/mask
dst_port
dst_port_min
dst_port_max
src_ipaddress/src_mask
src_port
src_port_min
src_port_max
permit
qosprofile
deny
portlist
prec_number
Default
N/A
ExtremeWare 7.5 Command Reference Guide
command.
create access-list
Specifies the access list name. The access list name can be between 1 and
31 characters.
Specifies an IP destination address and subnet mask. A mask length of 32 indicates
a host entry.
any specifies that any address will match.
Specifies a UDP layer 4 port.
any specifies that all UDP ports will match.
Specifies the beginning of a UDP layer 4 port range.
Specifies the end of a UDP layer 4 port range.
Specifies a source IP address and subnet mask.
any specifies that any address will match.
Specifies a UDP layer 4 port.
any specifies that all UDP ports will match.
Specifies the beginning of a UDP layer 4 port range.
Specifies the end of a UDP layer 4 port range.
Specifies that packets that match the access list description are permitted to be
forward by this switch.
Specifies an optional QoS profile can be assigned to the access list, so that the
switch can prioritize packets accordingly.
Specifies that packets that match the access list description are filtered (dropped) by
the switch.
Specifies the ingress port(s) on which this rule is applied.
any specifies that the rule will be applied to all ports.
Specifies the access list precedence number. The range is 1 to 25,600.
create access-list udp destination source ports
939