Clear Log - Extreme Networks ExtremeWare Command Reference Manual

Commands for Status Monitoring and Statistics

clear log

For the "i" series switches:
clear log {diag-status | error-led | static | messages [memory-buffer |
nvram]}
For the "e" series switches:
clear log {diag-status | static | messages [memory-buffer | nvram]}
Description
Clears the log database.
Syntax Description
diag-status Clears the hardware error code.
error-led Clears the ERR LED on the MSM.
NOTE: This option is supported only on the BlackDiamond switches.
static Specifies that the messages in the NVRAM target are cleared, and the ERR LED on the MSM
is cleared (on platforms with the MSM).
memory-buffer Clears entries from the memory buffer.
nvram Clears entries from NVRAM
Default
N/A
Usage Guidelines
The switch log tracks configuration and fault information pertaining to the device.
By default, log entries that are sent to the NVRAM remain in the log after a switch reboot. The
and
log clear log messages memory-buffer
the and
clear log static
NVRAM target as well as the memory buffer target.
When there is a hardware failure, a hardware error code might be saved to the FLASH or NVRAM
(depending on the switch configuration). Upon reboot, the switch will not try to bring up a module
with an error code, so it will be shown in a failed state. Use the
clear the hardware error code, so the module can be brought up after the next reboot. This command
clears the state for all the modules.
For the BlackDiamond Switches. There are three ways to clear the ERR LED on the MSM for the
BlackDiamond switches: Clear the log, reboot the switch, or use the
To clear the ERR LED without rebooting the switch or clearing the log messages, use the
command.
error-led
658
commands remove entries in the memory buffer target;
clear log messages nvram
commands remove messages from the
clear log diag-status
clear log error-led
ExtremeWare 7.5 Command Reference Guide
clear
command to
command.
clear log