Configure Debug-Trace Slb-Connection - Extreme Networks ExtremeWare Command Reference Manual

configure debug-trace slb-connection

configure debug-trace slb-connection <debug level>
Description
This command records debug information to the syslog.
NOTE
This command is available only on the "i" series switches.
Syntax Description
debug level
Default
The default level is 0.
Usage Guidelines
The
debug level
the messages recorded at lower levels.
Example
The following command sets the reporting level for SLB connection errors to 3:
configure debug-trace slb-connection 3
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on"i" platforms only.
ExtremeWare 7.5 Command Reference Guide
Specifies a debug level:
0 — Records critical failures such as insufficient memory unexpected internal state.
1 — Records unaccepted or dropped connections, as well as physical ports removed from a
GoGo mode group since a failed health check and physical ports added to a GoGo mode
group since a passed health check.
2 — Records GoGo mode resources that fail health check, or that change health check status
from fail to pass. An associated debug level 1 message will accompany this message only if
this was either the first health-check to fail on a port, or the last remaining health-check to
pass on a port.
3 — Records all events associated with connecting and disconnecting resources, and some SLB
configuration debugging information.
4 — No additional information recorded.
5 — No additional information recorded.
range is 0 to 5. Higher levels record more verbose messages. Higher levels also record
configure debug-trace slb-connection
1185