Extreme Networks ExtremeWare Command Reference Manual page 710

Hide thumbs Also See for ExtremeWare:

Table of Contents

Commands for Status Monitoring and Statistics

If the faulty module is a master MSM, the slave MSM automatically becomes the master and sets the

faulty MSM to

. The new master MSM re-initializes and brings up all the I/O modules.

If the faulty module is a master MSM and there is no slave MSM, the system continues operation in a

"limited commands" mode. In the "limited commands" mode, the I/O slots are not initialized, and the

only commands allowed are those that do not affect the switch hardware configuration.

If the faulty module is a slave MSM, the fault is recorded in the slave MSM NVRAM, and the slave

MSM is taken off line.

To view the failure messages, use the

show diagnostics

To clear the MSM failure messages posted to the log, use the

command. This command

clears the error messages from the MSM NVRAM. If the MSM failed a system health check, this

command restores the MSM to full functionality. This command should only be used for additional

testing purposes and reproduction efforts of the original fault.

If you configure the system health check mode to

and no new errors are detected, the device

scanned now remains on line. This behavior is identical to the current behavior if you use the

The following command configures the system health checker to try ten times to bring a faulty MSM

back on line:

configure sys-health-check auto-recovery 10

This command was first available in ExtremeWare 6.1.9.

The system health check functionality was modified in ExtremeWare 6.2.1 to support packet memory

defect detection and mapping on selected I/O modules.

This command was modified in ExtremeWare 6.2.2 to support system health check and checksum error

checking on the BlackDiamond 6804 switch and to add the

Platform Availability

This command is available on the BlackDiamond switch only.

The packet-memory defect detection and mapping feature is supported only on selected I/O modules.

See the release note for your version of ExtremeWare for information on the supported modules.

ExtremeWare 7.5 Command Reference Guide

Extremeware 7.5