Show Flow-Redirect - Extreme Networks ExtremeWare Command Reference Manual

show flow-redirect

show flow-redirect <flow redirect>
Description
Displays the current configuration and statistics for flow redirection.
Syntax Description
flow redirect
Default
N/A
Usage Guidelines
If you do not specify a flow redirection policy, configuration and statistics for all flow redirection
policies are displayed.
The following fields are displayed:
Service Check
Timer Settings:
Flow IPSA Mode
Proto:
Dest:
L4-src-port:
Enabled:
Source:
# Servers Up:
ExtremeWare 7.5 Command Reference Guide
Specifies a flow redirection policy.
Displays the frequency and timeout settings for the flow redirection ping check, TCP port
check, and service check.
Displays the IP source address mode:
• Enumeration Mode—The default mode, used for network masks from /32 to /20.
• Subnet Mode—Used for network masks from /19 to /1.
The mode is selected automatically when you specify a network mask.
Displays the flow type.
• any—Forwards any traffic over any IP port.
• tcp—Forwards TCP traffic over a single IP port.
• tup—Forwards both TCP and UDP traffic over a single IP port.
• udp—Forwards UDP traffic over a single IP port.
Displays the destination IP address.
Displays the source port number.
Displays the status of flow redirection.
• Yes—Flow redirection is enabled.
• No—Flow redirection is not enabled.
• Displays the source IP address.
Displays the number of next hops up over the number of next hops configured.
show flow-redirect
631