Configure Route-Map Add - Extreme Networks ExtremeWare Command Reference Manual

Security Commands

configure route-map add

configure route-map <route-map> add <seq_number> [permit | deny] {match-one
| match-all} {set lpm-routing | set iphost-routing}
Description
Adds an entry in the route map with the specified sequence number and action.
NOTE
This command is available only on the "i" series switches.
Syntax Description
route-map The name of the route map to which this entry should be added.
seq-number Specifies a sequence number that uniquely identifies the entry, and determines the position of
the entry in the route map.
permit Permits the route.
deny Denies the route. This is applied only if the match is successful.
match-one The route map is successful as long as at least one of the matching statements is true.
match-all The route map is successful only when all match statements are true. This is the default
setting.
Default
N/A
Usage Guidelines
The sequence number determines the order of the entry in the route map.
The action (permit or deny) specifies the action to be taken on a successful match against the statements
in the route map.
After an entry has been added to the route map, statements must be added to define the routes that
should be matched, using the
This command can be used to override the VLAN LPM routing configuration for specific routes. The
and
set lpm-routing set iphost-routing
route-map matched IP prefixes. If the
forwarded to the IP prefixes' next hop by the ARM/MPLS module using LPM routing.
If the
set iphost-routing
next hop using the Inferno hardware host-based IP FDB. The
only for routes learned on VLANs that are not LPM routing enabled. The
keyword is significant only for routes learned on VLANs that are LPM routing enabled.
878
configure <route-map> add match
keywords specify how packets are to be routed for
property is added to a route-map, packets are
lpm-routing
property is added to a route-map, packets are forwarded to the IP prefixes'
command.
keyword is significant
set lpm-routing
set iphost-routing
ExtremeWare 7.5 Command Reference Guide