Enable Diffserv Replacement Ports - Extreme Networks ExtremeWare Command Reference Manual

enable diffserv replacement ports

enable diffserv replacement ports [<portlist> | all]
Description
Enables the DiffServ code point to be overwritten in packets transmitted by the switch.
NOTE
This command is available only on the "i" series switches.
Syntax Description
portlist Specifies a list of ports or slots and ports to which the parameters apply. May be in the form 1, 2,
3-5, 2:5, 2:6-2:8.
all Specifies that DiffServ replacement should be enabled for all ports.
Default
Disabled
Usage Guidelines
Eight user-defined code points can be configured on each port. The 802.1P priority bits (3-bits) are used
to select one of the eight code points.
Example
The following command enables DiffServ replacement on selected ports:
enable diffserv replacement ports 3,5,6
History
This command was available in ExtremeWare 6.0.
Platform Availability
This command is available on the "i" series platforms only.
ExtremeWare 7.5 Command Reference Guide
enable diffserv replacement ports
453