Extreme Networks ExtremeWare Command Reference Manual page 687

Table 14: Default Target Log Characteristics
Target
console display no
memory buffer
NVRAM
session
syslog
The built-in filter DefaultFilter and a severity level of
values may be overridden on a per-session basis by using the
command and specifying the target as
configuration changes:
configure log target session filter <filter name> {severity <severity> {only}}
Configuration changes to the current session target are in effect only for the duration of the session, and
are not saved in FLASH memory. The
changes are desired to be temporary. If changes to the console-display are to be permanent (saved to
FLASH memory), use the following form of the command:
configure log target console-display filter <filter name> {severity <severity> {only}}
In versions prior to ExtremeWare 7.1.0, so-called
above were stored in NVRAM so they would be available across a reboot. This remains the default
behavior for ExtremeWare releases, but message filtering for the NVRAM target is now configurable.
Example
The following command sends log messages that pass the filter myFilter and are of severity
and above to the previously configured syslog host at 10.31.8.25, port 8993, and facility
configure log target syslog 10.31.8.25:8993 local3 filter myFilter severity warning
The following command sends log messages that pass the filter myFilter and are of severity
and above to the current session:
configure log target session filter myFilter severity warning
History
This command was first available in ExtremeWare 7.1.0.
This command was added to the Summit "e" series of switches in ExtremeWare 7.2e.
Platform Availability
This command is available on all platforms.
ExtremeWare 7.5 Command Reference Guide
Enabled Severity Level Pre-7.1.0 Command to Set Log Severity
info
configure log display {<severity>}
yes debug-data N/A
yes warning N/A
no info N/A
no debug-data
configure syslog add <host name/ip> {: <udp-port>}
[local0... local7] <severity>
session
session
are used for each new telnet session. These
info
configure log target filter
. Use the following form of the command for per-session
option can also be used on the console display, if the
messages with a severity level of
static
configure log target filter
and
warning
warning
:
local3
warning
687