Extreme Networks ExtremeWare Command Reference Manual page 681

Version 7.5
Hide thumbs Also See for ExtremeWare:
Table of Contents

Advertisement

configure log filter events match
To see a list of event condition definitions, use the following command:
show log events
To see the current configuration of a filter, use the following command:
show log configuration filter <filter name>
Example
By default, all log targets are associated with the built-in filter called DefaultFilter. Therefore, the most
straightforward way to send additional messages to a log target is to modify DefaultFilter. In the
following example, the command modifies the built-in filter to allow incidents in the STP component,
and all subcomponents of STP, of severity critical, error, warning, notice and info. For any of these
events containing a physical port number as a match parameter, limit the incidents to only those
occurring on physical ports 3, 4 and 5 on slot 1, and all ports on slot 2:
configure log DefaultFilter add events stp severity info match ports 1:3-1:5, 2:*
You can use the
command to restore the DefaultFilter back to its
unconfigure log DefaultFilter
original configuration.
History
This command was first available in ExtremeWare 7.1.0.
This command was added to the Summit "e" series of switches in ExtremeWare 7.2e.
Platform Availability
This command is available on all platforms.
ExtremeWare 7.5 Command Reference Guide
681

Advertisement

Table of Contents
loading

This manual is also suitable for:

Extremeware 7.5

Table of Contents