Unconfigure Sflow Backoff-Threshold - Extreme Networks ExtremeWare Command Reference Manual

Hide thumbs Also See for ExtremeWare:

Table of Contents

Commands for Status Monitoring and Statistics

unconfigure sflow backoff-threshold

Removes the configured value of the sFlow backoff threshold and resets it to 0 (zero).

This command is available only on the "i" series switches.

Syntax Description

The command has no arguments or variables.

The default backoff threshold rate is 0 packets per second.

Usage Guidelines

This command removes the configured sFlow backoff threshold value and resets it to 0 (zero). The

backoff threshold feature is used to limit the number of packets sent to the sFlow collector in a second.

The backoff threshold is set by using the following command:

configure sflow backoff-threshold

If the number of packets sent to the collector exceeds the limit set by the

configure sflow

command, the sampling rate will be doubled.

backoff-threshold

The backoff threshold is enabled when the

command is executed

enable sflow backoff-threshold

and the sample rate set by the

command is greater than 0 (zero).

configure sflow sample-rate

The following command resets the sFlow backoff threshold value to 0 (zero):

unconfigure sflow backoff-threshold

This command was first available in ExtremeWare 7.3.0.

Platform Availability

This command is available on "i" series platforms.

ExtremeWare 7.5 Command Reference Guide

Extremeware 7.5