Configure Flowstats Source - Extreme Networks ExtremeWare Command Reference Manual
Version 7.5
Hide thumbs
Also See for ExtremeWare:
- Command reference manual (2620 pages) ,
- Command reference manual (2254 pages) ,
- Command reference manual (1598 pages)
Table of Contents
Advertisement
configure flowstats source
configure flowstats source
configure flowstats source ipaddress <ipaddress>
Description
Configures the IP address that is to be used as the source IP address for NetFlow datagrams to be
exported.
NOTE
This command is available only on the "i" series switches.
Syntax Description
ipaddress
Specifies the IP address of a VLAN to be used as the source address for the NetFlow datagrams.
Default
Uses the IP address of the VLAN that has the default route to the flow-collector device.
Usage Guidelines
The IP address must have a route to the flow-collector device.
Example
The following command specifies that IP address 198.168.100.1 is the source:
configure flowstats source ipaddress 198.168.100.1
History
This command was first available in ExtremeWare 6.2.
Platform Availability
This command is available only on the "i" series platforms.
ExtremeWare 7.5 Command Reference Guide
671
Advertisement
Table of Contents
