Configure Debug-Trace Mpls - Extreme Networks ExtremeWare Command Reference Manual

configure debug-trace mpls

configure debug-trace mpls <level>
Description
This command records debug information to the syslog.
NOTE
This command is available only on the "i" series switches.
Syntax Description
debug level
Default
The default level is 0.
Usage Guidelines
The
debug level
the messages recorded at lower levels.
Example
The following command sets the reporting level for MPLS errors to 3:
configure debug-trace mpls 3
Following is the log output at this level:
<DBUG:IPHS> Skipping FDB refresh for 10.3.1.1 due to LSP
<DBUG:IPHS> last message repeated 3 times
<DBUG:IPHS> Skipping FDB refresh for 10.3.1.1 due to LSP
<DBUG:IPHS> last message repeated 3 times
<DBUG:IPHS> Skipping FDB refresh for 10.3.1.1 due to LSP
<DBUG:IPHS> last message repeated 3 times
<DBUG:IPHS> Skipping FDB refresh for 10.3.1.1 due to LSP
ExtremeWare 7.5 Command Reference Guide
Specifies a debug level:
0 — None.
1 — Records error and warning messages, such as session up, state machine errors,
Initialization errors, label allocation errors, patricia tree failures, invalid message type or
format, memory allocation errors, NVRAM parse errors, TLS tunnel creation errors, socket
errors, label manager problems, and null pointer or handle.
2 — Records informational messages, such as LDP entity up, LDP parameter setting, LSP bind
event, NHLFE creation, and MPLS GPP and session down errors.
3 — Records debug information, such as
Release Msgs, Message encoding, Parameter setting, MPLS enable messages, Memory
initialization, TLS setup messages, Invalid value messages, LSP Init/Teardown msgs, Event
processing, RDB (route) callback information.
4 — Records more detailed debug information.
5 — No additional information recorded.
range is 0 to 5. Higher levels record more verbose messages. Higher levels also record
patricia Tree Adds/Deletes,
configure debug-trace mpls
Label Propagation and
1165