Configure Debug-Trace Flowstats - Extreme Networks ExtremeWare Command Reference Manual

configure debug-trace flowstats

configure debug-trace flowstats <debug level>
Description
This command records debug information to the system log.
NOTE
This command is available only on the "i" series switches.
Syntax Description
debug level
Default
The default level is 0.
Usage Guidelines
The
debug level
the messages recorded at lower levels.
Example
The following command sets the reporting level for flowstats errors to 3:
configure debug-trace flowstats 3
History
This command was first available in ExtremeWare 6.2.2.
Platform Availability
This command is available on"i" platforms only.
ExtremeWare 7.5 Command Reference Guide
Specifies a debug level:
0 — Records error messages, such as cannot open a socket, cannot bind a socket, or cannot
add or remove a flow from health-check.
1 — No additional information recorded.
2 — No additional information recorded.
3 — No additional information recorded.
4 — No additional information recorded.
5 — Displays informational messages, such as adding or deleting a flow collector.
6 — No additional information recorded.
7 — Displays debug messages such as enabling and disabling ping-check, IP address of flow
collector, and port, flow collector, and flow group information for each packet, as well as a
packet dump.
range is 0 to 5. Higher levels record more verbose messages. Higher levels also record
configure debug-trace flowstats
1145