show slb failover
show slb failover
Description
Displays SLB failover configuration and status.
Syntax Description
This command has no arguments or variables.
Default
N/A
Usage Guidelines
The
show slb global
Example
The following command displays the current SLB failover configuration and status:
show slb failover
Following is the output from this command:
SLB Failover Configuration:
Failover: Enabled
Local unit ID: 1
Local IP address: 10.1.1.1
Remote IP address: 10.1.1.2
TCP port number: 1028
Remote Alive frequency: 1
Remote Dead frequency: 2
Keepalive Timeout: 3
Ping check: Disabled
Ping check IP address: 0.0.0.0
Ping frequency: 1
Ping timeout: 3
Manual failback: Disabled
#
#
SLB Failover Status: Running
Units active in local SLB: 2
Units active in or
requested by remote SLB: None
Send connection: Down
Receive connection: Down
Ping check: Not Running
History
This command was first available in ExtremeWare 6.1.
ExtremeWare 7.5 Command Reference Guide
command also displays SLB failover configuration and status.
show slb failover
637