Enable Flowstats Filter Ports - Extreme Networks ExtremeWare Command Reference Manual

Version 7.5
Hide thumbs Also See for ExtremeWare:
Table of Contents

Advertisement

Commands for Status Monitoring and Statistics

enable flowstats filter ports

enable flowstats filter <filter#> ports <portlist> {ingress | egress}
Description
Enables a specified flow record filter for the specified ports.
NOTE
This command is available only on the "i" series switches.
Syntax Description
filter#
Specifies the flow record filter that should be enabled.
portlist
Specifies the ports or slots and ports for which the filter should be enabled. May be in the form 1, 2,
3-5, 2:5, 2:6-2:8.
ingress
Use this keyword to specify that the filter being enabled or disabled is one of the eight filters to be
applied to inbound flows on the SONET port(s).
NOTE: This option is available only on the PoS module.
egress
Use this keyword to specify that the filter being enabled or disabled is one of the eight filters to be
applied to outbound flows on the SONET port(s).
NOTE: This option is available only on the PoS module.
Default
For the PoS module, filter #1 is enabled on all SONET ports, and the remaining filters are disabled.
For other switches or modules, filters are enabled by default when they are configured.
Usage Guidelines
The
# parameter is an integer in the range [1-8]. A filter must be enabled to match a flow. For "i"
filter
series devices other than the PoS module, these apply only to outbound flows.
For each SONET port on a PoS module, sixteen filters are supported—eight filters for ingress flows and
another eight filters for egress flows. The
keyword are used to identify the particular filter that is being disabled.
One of either the
ingress
Example
The following command enables filter 3 for ports 1-8 on the switch:
enable flowstats filter 3 ports 1-8
History
This command was first available in ExtremeWare 6.1.5b20 for the PoS module only.
This command was first available in ExtremeWare 6.2 for all "i" series platforms.
748
# parameter and either the
filter
or
keywords are required for SONET ports.
egress
or
ingress
egress
ExtremeWare 7.5 Command Reference Guide

Advertisement

Table of Contents
loading

This manual is also suitable for:

Extremeware 7.5

Table of Contents