Configure Debug-Trace Eaps-System - Extreme Networks ExtremeWare Command Reference Manual

configure debug-trace eaps-system

configure debug-trace eaps-system <debug level>
Description
This command records debug information to the syslog.
NOTE
This command is available only on the "i" series switches.
Syntax Description
debug level
vlan name
Default
The default level is 0.
Usage Guidelines
The
debug level
the messages recorded at lower levels.
Example
The following command sets the reporting level for EAPS errors to 3:
configure debug-trace eaps-system 3
Following is the log output at this level:
<INFO:SYST> serial admin: configure debug-trace eaps-system 0
<DBUG:EAPS> eaps_runtime.c 1673: Complete state unchanged, EAPS="man1"
<DBUG:EAPS> eaps_runtime.c 931: Pdu="Health-Pdu", EAPS="man1" [MAC=00:01:30:33:14:00],
RcvdSeq#=14851, CurrSeq#
<DBUG:EAPS> eaps_runtime.c 852: pdu="Health-Pdu"
<DBUG:EAPS> eaps_runtime.c 843: [DEBUG] vlanId=10, eapsdInst=0
<DBUG:EAPS> eaps.c 520: [DEBUG] Found Control Vlan. EapsInst=0
<DBUG:EAPS> eaps.c 368: [DEBUG] Wowie!! Received EAPS_PDU_MSG
ExtremeWare 7.5 Command Reference Guide
Specifies a debug level:
0 — Records software bugs and severe errors.
1 — Records warning messages.
2 — Records changes in state, such as a failure, and changes in port status, such as a port
going down.
3 — Records events that do not cause a state change and basic debug information, such as
failed PDU transmission, disabled or unconfigured ports, or inactive links.
4 — Records frequently occurring events, such as timers expiring, and detailed debug
information, such as sending or receiving PDUs, VLAN ID and EAPS domain of each PDU,
and configuration values.
5 — No additional information recorded.
Specifies a VLAN name.
range is 0 to 5. Higher levels record more verbose messages. Higher levels also record
configure debug-trace eaps-system
1141