Enable Dlcs - Extreme Networks ExtremeWare Command Reference Manual

QoS Commands

enable dlcs

enable dlcs {fast-etherenable dlcs net-ports | ports [all | <port_number>]}
Description
This command enables Windows Internet Naming Service (WINS) snooping for ports on the switch.
NOTE
This command is available only on the "i" series switches.
Syntax Description
fast-ethernet-ports Specifies that WINS packets should be snooped on all Fast Ethernet ports.
all Specifies that WINS packets should be snooped on all ports.
port_number Specifies a port on which WINS packets are to be snooped.
Default
Enables snooping on all ports.
Usage Guidelines
DLCS must be enabled to allow usage of DLCS information by the ExtremeWare Enterprise Manager
Policy System.
is used to enable DLCS on the system, and
enable dlcs
DLCS on all ports. For DLCS to work properly both commands need to be executed. See PD3-26670001
for more details.
The
fast-ethernet-ports
than having to enter each port individually.
Example
The following command enables DLCS snooping on port 4:
enable dlcs ports 4
Use the following commands to enable DLCS snooping on the system and on all ports:
enable dlcs
enable dlcs ports all
History
This command was available in ExtremeWare 6.0.
The command was modified in ExtremeWare 6.1 to support the
454
parameter is a shortcut to enable DLCS on all Fast Ethernet ports, rather
enable dlcs ports all
fast-ethernet-ports
is used to enable
parameter.
ExtremeWare 7.5 Command Reference Guide