NAT Commands
configure nat udp-timeout
configure nat udp-timeout <seconds>
Description
Configures the timeout for a UDP session.
Syntax Description
seconds
Specifies the number of seconds to wait before the session table entry times out.
Default
Default timeout is 120 seconds.
Usage Guidelines
Setting the timeout to zero specifies that session table entries should not be timed out. This setting is not
normally recommended, because NAT resources will be used up.
Example
The following command configures the timeout for a UDP session to 90 seconds:
configure nat udp-timeout 90
History
This command was first available in ExtremeWare 6.2.
This command was added to the Summit "e" series of switches in ExtremeWare 7.1e.
Platform Availability
This command is available on all platforms.
484
ExtremeWare 7.5 Command Reference Guide