Disable Flowstats Filter Ports - Extreme Networks ExtremeWare Command Reference Manual

Hide thumbs Also See for ExtremeWare:

Table of Contents

Commands for Status Monitoring and Statistics

disable flowstats filter ports

disable flowstats filter <filter#> ports <portlist> {ingress | egress}

Disables a specified flow record filter for the specified ports.

This command is available only on the "i" series switches.

Syntax Description

Specifies the flow record filter that should be disabled.

Specifies a list of ports or slots and ports for which the filter should be disabled. May be in the form 1,

2, 3-5, 2:5, 2:6-2:8.

Use this keyword to specify that the filter being enabled or disabled is one of the eight filters to be

applied to inbound flows.

NOTE: This option is available only on the PoS module.

Use this keyword to specify that the filter being enabled or disabled is one of the eight filters to be

applied to outbound flows.

NOTE: This option is available only on the PoS module.

For the PoS module, filter #1 is enabled on all SONET ports, and the remaining filters are disabled.

For other switches or modules, filters are enabled by default when they are configured.

Usage Guidelines

# parameter is an integer in the range 1 to 8.

For each SONET port on a PoS module, sixteen filters are supported—eight filters for ingress flows and

another eight filters for egress flows. The

keyword are used to identify the particular filter that is being disabled.

One of either the

The following command disables filter 3 for ports 1-8 on an "i" series switch:

disable flowstats filter 3 ports 1-8

The following command example disables ingress filter #2 on port 1 of the PoS module installed in

slot 8 of the BlackDiamond switch:

disable flowstats filter 2 ports 8:1 ingress

# parameter and either the

keywords are required for SONET ports.

ExtremeWare 7.5 Command Reference Guide

Extremeware 7.5