Configure Slb Pool Add - Extreme Networks ExtremeWare Command Reference Manual

SLB Commands—"i" Series Switches Only

configure slb pool add

configure slb pool <pool name> add <ip address>:[ftp | http | https | imap4
| ldap | nntp | pop3 | smtp | socks | telnet | tftp | web | wildcard | www
| <TCP or UDP port number>] {ratio <number> | priority <number>}
Description
Adds a node to a pool.
Syntax Description
pool name
ip address
ftp
http
https
imap4
ldap
nntp
pop3
smtp
socks
telnet
tftp
web
wildcard
www
TCP or UDP port number
ratio
priority
Default
The default ratio is 1.
The default priority is 1.
Usage Guidelines
This command also configures the ratio or priority for the ratio and priority load balancing methods.
You must create the pool before you add nodes. When you add a new node, ping check is automatically
enabled.
A ratio of 2 results in twice as much traffic as a ratio of 1. If all nodes use the same ratio, connections
are distributed equally among the nodes. A ratio of 0 results in no traffic to the node. When you
552
Specifies a pool.
Specifies the IP address of the node.
Specifies an FTP node.
Specifies an HTTP node.
Specifies an HTTPS node.
Specifies an IMAP4 node.
Specifies an LDAP node.
Specifies an NNTP node.
Specifies a POP3 node.
Specifies an SMTP node.
Specifies a SOCKS node.
Specifies a telnet node.
Specifies a TFTP node.
Specifies a Web node.
Specifies any port associated with a wildcard server.
Specifies a www node
Specifies a TCP or UDP port for the node.
Specifies the ratio for the ratio load balancing method. The range is 0 to 65,535.
Specifies the priority for the priority load balancing method. The range is 1 to 65535.
ExtremeWare 7.5 Command Reference Guide