Create Fdbentry Vlan Dynamic - Extreme Networks ExtremeWare Command Reference Manual

create fdbentry vlan dynamic

For "i" series switches:
create fdbentry [<mac_address> | broadcast-mac | any-mac] vlan <vlan name>
dynamic [qosprofile <qosprofile> {ingress-qosprofile <inqosprofile>} |
ingress-qosprofile <inqosprofile> {qosprofile <qosprofile>}]
For "e" series switches:
create fdbentry [<mac_address> | any-mac] vlan <vlan name> dynamic
[ingress-qosprofile <qosprofile> {ingress-qosprofile <inqosprofile>}]
Description
Creates a permanent dynamic FDB entry, and associates it with an ingress and/or egress QoS profile.
Syntax Description
mac_address
broadcast-mac
any-mac
vlan name
dynamic
qosprofile
inqosprofile
Default
N/A
Usage Guidelines
This command is used to associate QoS profiles with packets received from or destined for the specified
MAC address, while still allowing the FDB entry to be dynamically learned.
The FDB entry is not actually created until the MAC address is encountered as the source MAC address
in a packet. Thus, initially the entry may not appear in the
learned, it is created as a permanent dynamic entry, designated by "dpm" in the flags field of the
output.
fdb
A dynamic entry is flushed and relearned (updated) when any of the following take place:
• A VLAN is deleted.
• A VLAN identifier (VLANid) is changed.
• A port mode is changed (tagged/untagged).
• A port is deleted from a VLAN.
ExtremeWare 7.5 Command Reference Guide
Specifies a device MAC address, using colon separated bytes.
Specifies the broadcast MAC address. May be used as an alternate to the colon-separated
byte form of the address ff:ff:ff:ff:ff:ff.
NOTE: This option is only available on the "i" series of switches.
Specifies the wildcard, permanent FDB entry used to give higher priority to an 802.1p packet.
Specifies a VLAN name associated with a MAC address.
Specifies that the entry will be learned dynamically.
QoS profile associated with the destination MAC address of the egress port.
QoS profile associated with the source MAC address of the ingress port.
NOTE: This option is only available on the "i" series of switches.
output. Once the entry has been
show fdb
create fdbentry vlan dynamic
show
413