Configure Transceiver-Test Failure-Action - Extreme Networks ExtremeWare Command Reference Manual

Commands for Status Monitoring and Statistics

configure transceiver-test failure-action

configure transceiver-test failure-action [log | sys-health-check]
Description
Configures the action the switch takes if too many failures are detected within the specified window.
NOTE
This command is available only on modular switches.
Syntax Description
log Specifies that messages are sent to the syslog.
sys-health-check Specifies that the configured system health check action is taken.
Default
Log
Usage Guidelines
If you select , only one instance of an error message is logged at this level.
log
If you select
sys-health-check
configured system health check action. To configure the system health checker, use the
sys-health-check alarm-level
The alarm-level and auto-recovery options are mutually exclusive; configuring an alarm level disables
auto-recovery, and configuring auto-recovery overrides the alarm-level setting.
By default, the switch checks for errors within the last eight 20-second windows. Use the
transceiver-test window
To determine if you have the transceiver test enabled and the failure action the switch takes, use the
command. The following is sample transceiver test output:
show switch
Transceiver Diag: Enabled.
For ExtremeWare 6.2.2b108:
The default is
sys-health-check
Example
The following command configures the switch to perform the configured system health check action if
too many failures are detected:
configure transceiver-test failure-action sys-health-check
History
This command was first available in ExtremeWare 6.2.2b108.
718
and the switch detects too many failures, the switch takes the
or the
configure sys-health-check auto-recovery
command to modify the number of windows.
Failure action:
, and the switch takes the configured system health check action.
log only
configure
command.
configure
ExtremeWare 7.5 Command Reference Guide