Create Access-Mask - Extreme Networks ExtremeWare Command Reference Manual

create access-mask

create access-mask <access-mask name> {dest-mac} {source-mac} {vlan} {tos
|code-point} {ethertype} {ipprotocol} {dest-ip/<mask length>}
{source-L4port | {icmp-type} {icmp-code}} {permit-established} {egressport}
{ports} {precedence <number>}{vlan-pri}{vlan-pri-2bits}
Description
Creates an access mask.
NOTE
This command is available only on the "e" series switches.
Syntax Description
access mask name
dest-mac
source-mac
vlan
tos
code-point
ethertype
ipprotocol
dest-ip
source-ip
mask length
dest-L4port
source-L4port
icmp-type
icmp-code
permit-established
egressport
ports
precedence
vlan-pri
vlan-pri-2bits
bgp-community
vlan
ExtremeWare 7.5 Command Reference Guide
Specifies the name of the access-mask.
Specifies the destination MAC address.
Specifies the source MAC address.
Specifies the VLANid.
Specifies a 3-bit precedence field within the IP ToS field. Valid entries are from 0 to 7.
Specifies a 6-bit DiffServ code point. Valid entries are from 0 to 63.
Specifies the Ethernet type field.
Specifies the IP protocol.
Specifies the destination IP address.
Specifies the source IP address.
Specifies the IP mask length
Specifies the destination TCP/UDP port.
Specifies the source TCP/UDP port.
Specifies the ICMP type.
Specifies the ICMP code.
Specifies the TCP SYN and ACK bits. It is specified when IP protocol is implicit and need
not be specified separately.
Specifies the egress port.
Specifies one or more ingress ports.
Specifies the access-mask precedence, which determines the precedence of the
associated access list.
Specifies the 802.1p priority of the VLAN tag, which is a three-bit field. Valid values are 0
to 7.
Specifies the two most significant bits of the vlan-pri field.
Specifies that the profile entries will be a list of BGP community numbers. Not supported
on the Summit 400 switch.
Specifies that the profile entries will be a list of VLANs
create access-mask
941